Snmp Configuration Settings - Qlogic SANbox 5000 Series Interface Manual

A
Set Setup SNMP
Configures SNMP on the switch.
Authority
Admin session
Syntax
set setup snmp
Prompts you in a line-by-line fashion to change SNMP configuration settings.
Table 14-25
press the Enter key to accept the current value shown in brackets.
SNMPEnabled
Contact
Location
Trap [1-5] Address
Trap [1-5] Port
Trap [1-5] Severity
Trap [1-5] Version
Trap [1-5] Enabled
ReadCommunity
59183-02 A
describes the SNMP fields. For each parameter, enter a new value or
Table 14-25. SNMP Configuration Settings
Entry
Enables (True) or disables (False) SNMP on the switch. The
default is True.
Specifies the name of the person to be contacted to respond to
trap events. The name can be up to 64 characters excluding #,
semicolon (;), and comma (,). The default is undefined. This
value is also passed to the Call Home service configuration.
Specifies the name of the switch location. The name can be up
to 64 characters excluding #, semicolon (;), and comma (,).
The default is undefined. This value is also passed to the Call
Home service configuration.
Specifies the workstation IP address to which SNMP traps are
sent. The default address for trap 1 is 10.0.0.254. The default
address for traps 2–5 is 0.0.0.0. Addresses, other than 0.0.0.0,
for all traps must be unique.
Specifies the workstation port to which SNMP traps are sent.
Valid workstation port numbers are 1–65535. The default is
162.
Specifies the severity level to use when monitoring trap events.
The default is Warning.
Specifies the SNMP version (1 or 2) to use in formatting traps.
The default is 2.
Specifies whether traps (event information) are enabled or dis-
abled (default).
Read community password that authorizes an SNMP agent to
read information from the switch. This is a write-only field. The
value on the switch and the SNMP management server must
be the same. The read community password can be up to 32
characters excluding #, semicolon (;), and comma (,). The
default is "public".
14 – Command Reference
Set Setup SNMP
Description
14-103