Port Configuration Parameters - Qlogic SANbox 5000 Series Interface Manual

14 – Command Reference
Set Config Port
Set Config Port
Sets the port configuration parameters for one or more ports. The changes you
make with this command are not retained when you reset or power cycle the
switch unless you save them using the Config Save command.
Authority
Admin session and a Config Edit session
Syntax
set config port [port_number]
or
set config ports [port_number]
Keywords
port [port_number]
Initiates an edit session in which to change configuration parameters for the port
number given by [port_number]. If you omit [port_number], the system begins with
port 0 and proceeds in order through the last port. For each parameter, enter a
new value or press the Enter key to accept the current value shown in brackets.
Enter "q" to end the configuration for one port, or "qq" to end the configuration for
all ports.
ports [port_number]
Initiates an editing session in which to change configuration parameters for all
ports based on the configuration for the port given by [port_number]. If you omit
[port_number], port 0 is used. For each parameter, enter a new value or press the
Enter key to accept the current value shown in brackets. Enter "q" to end the
configuration.
AdminState
LinkSpeed
14-72
Table 14-16 describes the port configuration parameters.
Table 14-16 describes the port configuration parameters.
Table 14-16. Port Configuration Parameters
Parameter
Port administrative state:
Transmission speed:
Description
Online – Activates and prepares the port to send data.
This is the default.
Offline – Prevents the port from receiving signal and
accepting a device login.
Diagnostics – Prepares the port for testing and prevents
the port from accepting a device login.
Down – Disables the port by removing power from the
port lasers.
1/2/4-Gbps Ports: 1-Gbps, 2 Gbps, 4-Gbps, or Auto. The
default is Auto.
10-Gbps Ports: 10-Gbps or Auto. The default is Auto.
S
59183-02 A