B-12 System Configuration Settings - Qlogic SANbox2-16 Fibre Channel Installation Manual


TrapCommunity
AuthFailureTrap
system
Prompts you in a line-by-line fashion to change system configuration settings.
Table B-12
new value or press the Enter key to accept the current value shown in brackets.
Eth0NetworkAddress
Eth0NetworkMask
Eth0GatewayAddress
Eth0NetworkDiscovery
AdminTimeout
SecurityEnabled
LocalLogEnabled
RemoteLogEnabled
RemoteLogHostIPAddress
59021-05 A
Table B-11. SNMP Configuration Settings
Entry
Trap community password that authorizes an SNMP agent
to receive traps. This is a write-only field. The value on the
switch and the SNMP management server must be the
same. The default is "public".
Specifies the IP address where a notification is sent in the
event of an authentication failure.
describes the system configuration fields. For each parameter, enter a
Table B-12. System Configuration Settings
Entry
Description
Description
Internet Protocol (IP) address for the Ethernet port.
Subnet mask address for the Ethernet port.
IP address gateway.
Boot Method (1 - Static, 2 - Bootp, 3 - DHCP, 4 -
RARP)
Specifies the amount of time in minutes the switch
waits before terminating an idle Admin session.
Zero (0) disables the time out threshold. The
default is 30, the maximum is 1440.
Enables or disables the enforcement of account
names and passwords.
Enables or disables the saving of log information
on the switch.
Whether remote logging of is enabled or disabled.
If enabled, log information is saved to a remote
host that supports the syslog protocol.
The IP address of the host that will receive the
remote log information if remote logging is
enabled.
B – Command Line Interface
Set Setup Command
B-39