Qlogic SANbox 5000 Series Interface Manual page 172

14 – Command Reference
Firmware Install
The following is an example of the Firmware Install command using TFTP:
SANbox #> admin start
SANbox (admin) #> firmware install
The switch will be reset.
to I/O traffic.
Continuing with this action will terminate all management sessions,
including any Telnet sessions. When the firmware activation is complete,
you may log in to the switch again.
Do you want to continue? [y/n]: y
Press 'q' and the ENTER key to abort this command.
FTP or TFTP
IP Address
Source Filename : 6.8.00.11_mpc
About to install image.
Connected to 10.0.0.254 (10.0.0.254).
220 localhost.localdomain FTP server (Version wu-2.6.1-18) ready.
bin
200 Type set to I.
verbose
Verbose mode off.
This may take several seconds...
The switch will now reset.
Connection closed by foreign host.
14-26
This process will cause a disruption
: tftp
: 10.0.0.254
Do you want to continue? [y/n] y
S
59183-02 A