Copy A Switch Configuration; Delete A Switch Configuration; Modify A Switch Configuration - Qlogic SANbox 5000 Series Interface Manual

5 – Switch Configuration
Managing Switch Configurations
5.3.3

Copy a Switch Configuration

Enter the
shown in the following example:
SANbox (admin) config copy config_1 config_2
5.3.4

Delete a Switch Configuration

Enter the
shown in the following example. You cannot delete the active configuration nor the
default configuration (Default Config).
SANbox (admin) config delete config_2
5.3.5

Modify a Switch Configuration

To modify a switch configuration, you must open an Admin session with the
Start command. An Admin session prevents other accounts from making changes
at the same time through Telnet, Enterprise Fabric Suite 2007, or another
management application. You must also open a Config Edit session with the
Config
do not specify a configuration name the active configuration is assumed.
The Config Edit session provides access to the Set Config commands with which
you make modifications to the port, switch, port threshold alarm, or zoning
configuration components as shown:
SANbox #> admin start
SANbox (admin) #> config edit
The config named default is being edited.
SANbox (admin-config)#> set config port . . .
SANbox (admin-config)#> set config switch . . .
SANbox (admin-config)#> set config threshold . . .
SANbox (admin-config)#> set config zoning . . .
The Config Save command saves the changes you made during the Config Edit
session. In this case, changes to the configuration named Default are being saved
to a new configuration named config_10132003. However, the new configuration
does not take effect until you activate it with the Config Activate command:
SANbox (admin-config)#> config save config_10132003
SANbox (admin)#> config activate config_10132003
SANbox (admin)#> admin end
The Admin End command releases the Admin session for other administrators
when you are done making changes to the switch.
5-12
Config Copy command to create a copy of an existing configuration as
Config Delete command to delete a configuration from the switch as
Edit command and indicate which configuration you want to modify. If you
S
Admin
59183-02 A