A
7.1.3
Merged Zone Set Information
A merged zone set is a zone set that is received from another switch as a result of
a change in active zone sets. You can display the merged zone set on your switch
if the MergeAutoSave parameter is set to False. Refer to
Database" on page 7-10
parameter. Enter the
information as shown in the following example:
SANbox #> zoning merged
*********************************************************************
To permanently save the merged database locally, execute the
'zoning merged capture' command. To edit the merged database
use the 'zoning edit merged' command. To remove the merged database
use the 'zoning restore' command.
**********************************************************************
Merged (unsaved) Zoning Information
ZoneSet
-------
ZS1
7.1.4
Edited Zone Set Information
The edited zone set is a zone set that you were modifying when a change in
active zone set or a fabric merge occurred. Enter the
display the unsaved edited zone set information as shown in the following
example:
SANbox #> zoning edited
Edited (unsaved) Zoning Information
ZoneSet
-------
ZS1
59183-02 A
for more information about the MergeAutoSave
Zoning Merged
Zone
ZoneMember
----
----------
Z1
10:00:00:c0:dd:00:b9:f9
10:00:00:c0:dd:00:b9:fa
Z2
10:00:00:c0:dd:00:b9:fb
10:00:00:c0:dd:00:b9:fc
Zone
ZoneMember
----
----------
Z1
10:00:00:c0:dd:00:b9:f9
10:00:00:c0:dd:00:b9:fa
Displaying Zoning Database Information
"Configuring the Zoning
command to display merged zone set
Zoning Edited
7 – Zoning Configuration
command to
7-5