Qlogic SANbox 5000 Series Interface Manual page 142

13 – Simple Network Management Protocol Configuration
Managing the SNMP Service
Enter the
following example:
SANbox #> admin start
SANbox (admin) #> set setup services
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
PLEASE NOTE:
-----------
* Further configuration may be required after enabling a service.
* If services are disabled, the connection to the switch may be lost.
* When enabling SSL, please verify that the date/time settings
on this switch and the workstation from where the SSL connection
will be started match, and then a new certificate may need to be
created to ensure a secure connection to this switch.
TelnetEnabled
SSHEnabled
GUIMgmtEnabled
SSLEnabled
EmbeddedGUIEnabled
SNMPEnabled
NTPEnabled
CIMEnabled
FTPEnabled
MgmtServerEnabled
CallHomeEnabled
Do you want to save and activate this services setup? (y/n): [n]
You can display the SNMPEnabled parameters using the
Show Setup Services
13-2
Set Setup Services command to enable SNMP as shown in the
(True / False)
(True / False)
(True / False)
(True / False)
(True / False)
(True / False)
(True / False)
(True / False)
(True / False)
(True / False)
(True / False)
commands.
[True ]
[False]
[True ]
[False]
[True ]
[True ]
[False]
[False]
[True ]
[True ]
[True ]
Show Setup SNMP
S
or
59183-02 A