Table of Contents
Advertisement
B – Command Line Interface
Set Setup Command
TrapCommunity
AuthFailureTrap
ProxyEnabled
system
Prompts you in a line-by-line fashion to change system configuration settings.
Table B-14
new value or press the Enter key to accept the current value shown in brackets.
Note:
Eth0NetworkDiscovery
Eth0NetworkAddress
Eth0NetworkMask
Eth0GatewayAddress
FCNetworkDiscovery
FCNetworkAddress
FCNetworkMask
FCGatewayAddress
B-44
Table B-13. SNMP Configuration Settings (Continued)
Entry
Trap community password that authorizes an SNMP agent
to receive traps. This is a write-only field. The value on the
switch and the SNMP management server must be the
same. The default is "public".
Enables (True) or disables (False) the generation of traps in
response to trap authentication failures. The default is False.
Enables (True) or disables (False) SNMP communication
with other switches in the fabric. The default is True.
describes the system configuration fields. For each parameter, enter a
Changing the IP address will terminate all Ethernet management
sessions.
Table B-14. System Configuration Settings
Entry
Description
Description
Ethernet boot method: 1 - Static, 2 - Bootp, 3 -
DHCP, 4 - RARP. The default is 1 - Static.
Ethernet Internet Protocol (IP) address. The
default is 10.0.0.1.
Ethernet subnet mask address.
Ethernet IP address gateway.
Fibre Channel boot method: 1 - Static, 3 - DHCP.
The default is 1 - Static.
Fibre Channel Internet Protocol (IP) address for
the Ethernet port. The default is 0.0.0.0.
Fibre Channel subnet mask address. The default is
255.0.0.0.
Fibre Channel IP address gateway. The default is
10.0.0.254.
D
59042-03 A
Advertisement
Table of Contents
