Custom Firmware Installation - Qlogic SANbox 5000 Series Interface Manual

A
5.7.3

Custom Firmware Installation

A custom firmware installation downloads the firmware image file from a remote
host to the switch, unpacks the image file, and resets the switch in separate steps.
This allows you to choose the type of switch reset and whether the activation will
be disruptive
following example illustrates a custom firmware installation with a nondisruptive
activation.
1. Download the firmware image file from the workstation to the switch.
SANbox #> admin start
SANbox (admin) #> image fetch account_name ip_address filename
2. Display the list of firmware image files on the switch to confirm that the file
was loaded.
SANbox #> admin start
SANbox (admin) $> image list
3. Unpack the firmware image file to install the new firmware in flash memory.
SANbox (admin) $> image unpack filename
4. Wait for the unpack to complete.
Image unpack command result: Passed
59183-02 A
(Reset Switch command) or nondisruptive
If your workstation has an FTP server, you can enter the
command:
If your workstation has a TFTP server, you can enter the Image TFTP
command to download the firmware image file.
SANbox (admin) #> image tftp ip_address filename
If your workstation has neither an FTP nor a TFTP server, open an
FTP session and download the firmware image file by entering FTP
commands:
>ftp ip_address or switchname
user:images
password: images
ftp>bin
ftp>put filename
ftp>quit
5 – Switch Configuration
Installing Firmware
(Hotreset command). The
Image Fetch
5-23