Qlogic SANbox 5000 Series Interface Manual page 158

14 – Command Reference
Config
Config
Manages the Fibre Channel configurations on a switch. For information about
setting the port and switch configurations, refer to the
command on page
Authority
Admin session for all keywords except Backup and List
Syntax
config
activate [config_name]
backup
cancel
copy [config_source] [config_destination]
delete [config_name]
edit [config_name]
list
restore
save [config_name]
Keywords
activate [config_name]
Activates the configuration given by [config_name]. If you omit [config_name], the
currently active configuration is used. Only one configuration can be active at a
time.
backup
Creates a file named configdata, which contains the system configuration
information. This keyword does not require an Admin session. Configuration
backup files are deleted from the switch during a power cycle or switch reset.
cancel
Terminates the current configuration edit session without saving changes that
were made.
copy [config_source] [config_destination]
Copies the configuration given by [config_source] to the configuration given by
[config_destination]. The switch supports up to 10 configurations including the
default configuration.
delete [config_name]
Deletes the configuration given by [config_name] from the switch. You cannot
delete the default configuration (Default Config) nor the active configuration.
14-12
14-80.
S
"Set Config Switch"
59183-02 A