Authentication Failure - Qlogic SANbox 5000 Series Interface Manual

A
Notes
Primary and secondary secrets are not included in a switch configuration backup.
Therefore, after restoring a switch configuration, you must re-enter the primary
and secondary secrets. Otherwise, the switch will isolate because of an

authentication failure.

Refer to the
managing groups in security sets.
Examples
The following is an example of the Group Add command:
SANbox #> admin start
SANbox (admin) #> security edit
SANbox (admin-security) #> group add Group_1
A list of attributes with formatting and default values will follow
Enter a new value or simply press the ENTER key to accept the current value
with exception of the Group Member WWN field which is mandatory.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Group Name Group_1
Group Type ISL
Member (WWN)
Authentication (None / Chap)
PrimaryHash (MD5 / SHA-1)
PrimarySecret (32 hex or 16 ASCII char value)
SecondaryHash (MD5 / SHA-1 / None)
SecondarySecret (40 hex or 20 ASCII char value)
Binding (domain ID 1-239, 0=None)
Finished configuring attributes.
To discard this configuration use the security cancel command.
59183-02 A
"Securityset" command on page 14-67
[00:00:00:00:00:00:00:00] 10:00:00:c0:dd:00:90:a3
for information about
[None
[MD5
[
[None
[
[0
14 – Command Reference
Group
] chap
]
] 0123456789abcdef
]
]
]
14-33