Qlogic SANbox 5000 Series Interface Manual page 184

14 – Command Reference
Hotreset
Hotreset
Resets the switch for the purpose of activating the pending firmware without
disrupting traffic. This command terminates all management sessions, saves all
configuration information, and clears the event log. After the pending firmware is
activated, the configuration is recovered. This process may take a few minutes. To
save the event log to a file before resetting, enter the
Authority
Admin session
Syntax
hotreset
Notes
You can load and activate version 6.8.x firmware on an operating switch
without disrupting data traffic or having to re-initialize attached devices under
the following conditions:
Ports that are stable when the non-disruptive activation begins, then change
states, will be reset. When the non-disruptive activation is complete,
Enterprise Fabric Suite 2007 sessions reconnect automatically. However,
CLI and SSH sessions must be restarted manually.
This command clears the event log and all counters.
14-38
The current firmware version permits the installation and
non-disruptive activation of 6.8 firmware. Refer to the 6.8 Firmware
Release Notes for previous compatible firmware versions.
No changes are being made to switches in the fabric including
installing firmware, powering up, powering down, disconnecting or
connecting ISLs, and switch configuration changes.
No port on the switch is in the diagnostic state.
No zoning changes are being made on the switch.
No changes are being made to attached devices including powering
up, powering down, disconnecting, connecting, and HBA configuration
changes.
S
Set Log Archive command.
59183-02 A