B-26 System Configuration Settings - Qlogic SANbox 5600 Series Installation Manual

A
TrapCommunity
AuthFailureTrap
ProxyEnabled
system
Prompts you in a line-by-line fashion to change system configuration settings.
Table B-26
new value or press the Enter key to accept the current value shown in brackets.
NOTE:
Eth0NetworkDiscovery
Eth0NetworkAddress
Eth0NetworkMask
Eth0GatewayAddress
AdminTimeout
InactivityTimeout
59096-02 C
Table B-25. SNMP Configuration Settings (Continued)
Entry
Trap community password that authorizes an SNMP agent to
receive traps. This is a write-only field. The value on the switch
and the SNMP management server must be the same. The
trap community password can be up to 32 characters excluding
#, semicolon (;), and comma (,). The default is "public".
Enables (True) or disables (False) the generation of traps in
response to trap authentication failures. The default is False.
Enables (True) or disables (False) SNMP communication with
other switches in the fabric. The default is True.
describes the system configuration fields. For each parameter, enter a
Changing the IP address will terminate all Ethernet management
sessions.
Table B-26. System Configuration Settings
Entry
Ethernet boot method: 1 - Static, 2 - Bootp, 3 - DHCP,
4 - RARP. The default is 1 - Static.
Ethernet Internet Protocol (IP) address. The default is
10.0.0.1.
Ethernet subnet mask address.
Ethernet IP address gateway.
Amount of time in minutes the switch waits before termi-
nating an idle Admin session. Zero (0) disables the time
out threshold. The default is 30, the maximum is 1440.
Amount of time in minutes the switch waits before termi-
nating an idle Telnet command line interface session.
Zero (0) disables the time out threshold. The default is 0,
the maximum is 1440.
B – Command Line Interface
Set Setup Command
Description
Description
B-87