Advertisement
2–Event Messages
Alarm Events
(A1007.001C) (Security: Bad Authentication Flags)
Meaning:
Action:
(A1007.001D) (Ignoring RADIUS Server Radius_Server, invalid IP address configured)
Meaning:
Action:
(A1007.001F) (Access reject from RADIUS server IP_address:port for device on this port)
Meaning:
Action:
(A1007.0020) (MAX Retry count reached on CHAP Authentication Protocol Reset, failing
Authentication)
Meaning:
Action:
(A1007.0021) (No response to RADIUS access request for device on port port)
Meaning:
Action:
(A1007.0022) (Invalid response authenticator from RADIUS server IP_address:port, check
shared secret)
Meaning:
Action:
2-40
The received AUTH frame did not meet the standard format for the
frame payload. Within the header portion of the payload, there are
some flags that are supposed to be set to zero (0). This frame has
the flags set to something other than zero (0).
Check the remote device for a possible error condition. Reset the
port to retry again. If errors continue, disable Challenge Handshake
Authentication Protocol (CHAP) for this device if it belongs in the
fabric.
A Remote Authentication Dial In Service (RADIUS) server could
not be found at the configured IP address.
Check the RADIUS server, or change the configuration to use an
IP address for a valid RADIUS server.
Security authentication has reached the maximum retry count. The
port will now isolate.
Check the security configuration.
A Remote Authentication Dial In Service (RADIUS) server has
rejected a RADIUS authentication request.
Check the configuration on both the switch and on the RADIUS
server for incompatibilities.
A configured Remote Authentication Dial In Service (RADIUS)
server did not respond to an authentication request within the
timeout period.
Check RADIUS server configuration and the RADIUS server.
There is a Remote Authentication Dial In Service (RADIUS) server
configuration problem.
Check the shared secret. The shared secret must be configured on
both the RADIUS server and the switch.
59060-07 D
Advertisement
