Advertisement
2–Event Messages
Alarm Events
(A1005.0106) (Fabric translation setup error, PLOGI from fc_id to fc_id OX_ID ox_id
rejected)
Meaning:
Action:
(A1005.0107) (TR Proxy Login failed: wwn already logged into local fabric at FC-ID fc_id)
Meaning:
Action:
(A1005.0108) (TR Port internal error encountered)
Meaning:
Action:
(A1005.0109) (TR ignored if_zone and if_zone; port_wwn> shared but two TR ports
port_wwn, port_wwn used)
Meaning:
Action:
(A1005.010A) (Remote fabric attached to port does not support NPIV)
Meaning:
Action:
(A1005.010B) (IPSec configuration error: IKE Peer peer_name : error_description)
Meaning:
Action:
2-32
A Port Login (PLOGI) from one transparent route endpoint to
another was rejected because of hardware resource limitations on
the TR_Port or the F/FL port involved in the mapping.
If there are 32 active transparent routes on the TR_Port, reduce
the number of mappings on that port, or use a different TR port. If
there are 32 active transparent routes on the F/FL_Port, reduce the
number of mappings on that port.
A proxy for a device in a remote fabric could not be created in the
name server of the local fabric because a device with the same
port name was already logged in.
Examine the adapters with the given WWN and determine which is
using the incorrect world wide name.
An internal inconsistency was detected by the switch firmware that
affected a transparent route.
Contact your authorized maintenance provider.
The zone set contains inter-fabric zones (IFZ) that shared the
same device port name, but uses different TR_Ports on the same
switch.
Remove one of the inter-fabric zones or modify them so that both
zones use the same TR_Port.
A TR_Port could not log into a remote fabric because the remote
fabric port does not support N_Port ID Virtualization (NPIV).
Enable NPIV on the switch attached to the TR_Port, or use a
different remote fabric switch port.
An error occurred while processing the specified peer in a saved
IKE configuration. None of the configuration modifications have
been applied to the switch's active database.
Correct the configuration and save it.
59060-07 D
Advertisement
