Advertisement
(A1005.006D) (Unable to synchronize with NTP server)
Meaning:
Action:
(A1005.006E) (A reset is required to activate this version of firmware)
Meaning:
Action:
(A1005.006F) (Hotreset Vversion -> Vversion is not supported)
Meaning:
Action:
(A1005.0070) (Hotreset to older firmware version not supported. A reset is required to
activate this version of firmware)
Meaning:
Action:
(A1005.0071) (Unable to obtain dynamic IP address, falling back to static IP address of
address on interface interface)
Meaning:
Action:
(A1005.0072) (Unable to turn off lasers, please power off the switch)
Meaning:
Action:
(A1005.0073)(Blade fault fault reported)
Meaning:
Action:
59060-07 D
The switch was unable to synchronize its time clock with the
Network Time Protocol (NTP) server.
Confirm that the NTP service and NTP client are enabled. Confirm
that the NTP server IP address is correct and that the server is
operating.
The installed firmware cannot be activated without disrupting I/O
traffic.
Perform a hard reset.
The installed firmware cannot be activated without disrupting I/O
traffic.
Perform a hard reset.
The installed firmware cannot be activated without disrupting I/O
traffic.
Perform a hard reset.
The switch was unable to obtain its IP address from the Dynamic
Host Configuration Protocol (DHCP) server. The static IP address
will be used.
Investigate the DHCP server.
Conditions exist that could damage the switch and the switch was
unable to turn off the Fiber Channel port lasers.
Power down the switch and contact your authorized maintenance
provider.
The named blade fault has occurred.
Contact your authorized maintenance provider.
2–Event Messages
Alarm Events
2-29
Advertisement
