Advertisement
(A1005.0039) (Fabric Login (FLOGI) from address FC_address failed)
Meaning:
Action:
(A1005.003A) (Fabric Login (FLOGI) from address FC_address failed
authorization/authentication)
Meaning:
Action:
(A1005.003B) (Warning - Debug logging filter level is set)
Meaning:
Action:
(A1005.003C) (User Port(s) port_numbers, isolated, lost steering path, administering them
to state DOWNED.)
Meaning:
Action:
(A1005.003E) (Warning, port(s) port_numbers configured ONLINE, but remain DOWN after
NDCLA.)
Meaning:
Action:
(A1005.003F) (Badly formatted SML Notification Ack session session_ID string - string)
Meaning:
Action:
(A1005.0040) (Unsupported SFP within port.)
Meaning:
Action:
(A1005.0041) (Setting port admin state DOWN due to POST failure)
Meaning:
Action:
59060-07 D
The payload of the FLOGI was not valid.
Check the device connection or replace the device. If the problem
persists, contact your authorized maintenance provider.
Security authentication failed.
Check the security configuration on both the device and the switch
to ensure that they are configured properly.
Debug logging has been set using the Set Log Level command.
Confirm that you intended to do this. If not, use the Set Log Level
command to change the severity level to Info, Warn, or Critical.
The ports required for steering the user ports have failed.
Contact your authorized maintenance provider.
Ports that were down before a non-disruptive code load and
activation remain down. This message serves as a reminder
because the alarm log is cleared during the non-disruptive code
load and activation.
None
The switch sent a notification that was not formatted correctly;
there may be a resource problem on the switch.
If this is a recurring message, contact your authorized maintenance
provider.
An unsupported SFP transceiver was installed in the port.
Replace the transceiver.
The port failed the power-on self test and has been disabled.
Contact your authorized maintenance provider.
2–Event Messages
Alarm Events
2-23
Advertisement
