Advertisement
2–Event Messages
Alarm Events
(A1007.000A) (Security: Dropping lock held by domain domain_id for number seconds)
Meaning:
Action:
(A1007.000B) (Security: EFMD Rejected, bad revision)
Meaning:
Action:
(A1007.000C) (Security policy restrict mode, security db differs)
Meaning:
Action:
(A1007.000D) (Security policy in mode mode, other switch in mode mode, sec db conflict)
Meaning:
Action:
(A1007.000E) (Security: Auth challenge received from WWN port_WWN, not Authorized to
join)
Meaning:
Action:
(A1007.000F) (Security: Chap session Gen Response indicates error, chap unable to
authenticate)
Meaning:
Action:
2-38
A remote switch has held the fabric lock for too long. The local
switch is dropping the lock in order to send out a Exchange Fabric
Membership Data (EFMD) frame.
None
The remote switch is running at a different Exchange Fabric
Membership Data (EFMD) version level than the local switch. Ports
will isolate.
None
The current security policy calls for Restrict Mode, which means
that all switches in the fabric must have the same security
databases or the inter-switch links will not log in. In this case, the
security databases differ.
Reconfigure the active security set so that the ISL group members
are the same.
The security policy on the local switch differs from that of the
remote switch.
Configure the security policy on the remote switch to match that of
the local switch.
A challenge authentication frame was received from a remote
switch, but the local switch does not have an entry for itself within
the active security set ISL group.
Edit the ISL group to include the local switch.
An Authentication Response frame cannot be built because the
Challenge Handshake Authentication Protocol (CHAP) session is
not in the right state. The port will isolate.
Check the remote device for a possible error condition. Reset the
port to retry again. If errors continue, disable CHAP for this device
if the device belongs in the fabric.
59060-07 D
Advertisement
