Download Print this page

Qlogic 3000 Series Reference Manual page 34

Fibre channel event message fibre channel switch
Hide thumbs Also See for 3000 Series:

Advertisement

2–Event Messages
Alarm Events
(A1004.0049) (Eport Isolating due to Remote inactive)
Meaning:
Action:
(A1004.0050) (Maximum hard zoning member limit exceeded, Reverting to soft zoning.
Requires port reset.)
Meaning:
Action:
(A1004.0051) (Blade IO blade_number isolated due to startup problem)
Meaning:
Action:
(A1004.0052) (Eport Isolating due to Switch Binding failure)
Meaning:
Action:
(A1004.0053) (Adding Denial of Service entry for source FC Address 0xaddress)
Meaning:
Action:
(A1004.0054) (Eport Isolating due to Link to self)
Meaning:
Action:
(A1004.0055) (Chassis Interconnect cables misconfigured, see configuration guide for
optimal setup)
Meaning:
Action:
2-20
The remote switch is unresponsive, and the link has not been
brought up. The port will be isolated because the remote switch
failed to respond.
Investigate the remote switch for connection problems.
The maximum number of zone members associated with a port is
limited to 64. If this number is exceeded, the switch cannot enforce
hard zoning and will revert to soft zoning.
Reduce the number of zone members associated with the port and
reset the port.
There is an internal communication issue with an IO blade. It will
be set down until it clears.
If this problem persists, contact your authorized maintenance
provider.
A device attempted to login as an inter-switch link, but that device
was not configured in the switch binding list.
Add the device to the switch binding list.
A number of frames from the indicated address have been
received. These frames are from a source that is not zoned with
the destination. A denial of service entry will be set up to discard
these frames.
Investigate the source at the specified Fibre Channel address.
Two ports on the same switch cannot be connected together.
Disconnect one or both ports.
Two QLogic 9000 switches are interconnected with HyperStacking
cables in a manner that is not supported.
Refer to the Installation Guide for information about how to connect
QLogic 9000 switches with HyperStacking cables.
59060-07 D

Advertisement

loading

This manual is also suitable for:

5000 series9000 series