Connecting The Cable; Connecting A Summitstack 128G/20G Stacking Cable - Extreme Networks Summit X150 Series Hardware Installation Manual

Chapter 5: Building a SummitStack Configuration

Connecting the Cable

To connect a SummitStack 128G cable:
1 Holding the cable connector with the release tab on top, align the connector with the stacking port
on the VIM1 module in the Summit X650 series switch
Figure 144: Connecting a SummitStack 128G Cable
2 Firmly press the cable connector into the stacking port until the spring latch on top of the connector
clicks into place.
3 Repeat steps 1 and 2

Connecting a SummitStack 128G/20G Stacking Cable

SummitStack 128G/20G cables are used to connect the 128-Gbps stacking ports on Summit X650 series
switches to 20-Gbps stacking ports on Summit X650 series or other Summit series switches. The
128-Gbps ports are on VIM1-SummitStack256 modules in Summit X650 series switches. The 20-Gbps
ports are on one of the following:
VIM1-10G8X module installed in a Summit X650 series switch
●
VIM1-SummitStack module in a Summit X650 series switch
●
VIM2-SummitStack module in a Summit X480 series switch
●
Rear panel of Summit X250e, X450, X450a, or X450e series switches.
●
202
SH_121
to connect the other end of the cable.
(Figure 144).
Summit Family Switches Hardware Installation Guide