Vim1-Summitstack256 Versatile Interface Module; Vim3-40G4X Versatile Interface Module - Extreme Networks Summit X150 Series Hardware Installation Manual

VIM1-SummitStack256 Versatile Interface Module

The VIM1-SummitStack256 versatile interface module
stacking ports. To connect these ports, you must use stacking cables with compatible connectors,
available from Extreme Networks.
The VIM1-SummitStack256 module requires ExtremeXOS 12.4.1 software (or later) installed on the
Summit X650 series switch.
Figure 107: VIM1-SummitStack256 Versatile Interface Module
Stacking
port

VIM3-40G4X Versatile Interface Module

The VIM3-40G4X versatile interface module
optical modules or QSFP+ compatible direct-attach active or passive cables. Ports S3 and S4 can be
enabled as native stacking ports for the Summit X650 series switch.
Each physical port can be configured to operate as a single 40-Gbps port or as four 10-Gbps ports.
When the port operates in 40-Gbps mode, you can connect the port using either a QSFP+ direct-attach
cable or an installed QSFP+ module and compatible fiber optic cable. When the port is configured to
operate in 10-Gbps mode, you must connect it using a special 1-to-4 breakout fiber optic cable.
The VIM3-40G4X module requires ExtremeXOS 12.6.1 software (or later) installed on the Summit X650
series switch.
Figure 108: VIM3-40G4X Versatile Interface Module
1
2
1 = QSFP+ port
2 = Port LEDs
Summit Family Switches Hardware Installation Guide
Versatile Interface Modules for the Summit X650 Series Switches
(Figure
LEDs
(Figure 108) provides four unpopulated cages for QSFP+
107) provides two 128-Gbps SummitStack
Stacking
port
SH_168
SH_251
147