Removing A Summit X480 Series Switch; Removing A Summit 450 W Or 550 W Ac Power Supply - Extreme Networks Summit X150 Series Hardware Installation Manual

Chapter 13: Removing a Summit Family Switch from a Rack

Removing a Summit X480 Series Switch

This section provides procedures for removing a Summit X480 series switch from a two-post or
four-post equipment rack.
Before you remove a Summit X480 series switch from the rack, remove all installed power supplies, as
described in the following sections:
"Removing a Summit 450 W or 550 W AC Power Supply" on page 362
●
"Removing a Summit 450 W or 550 W DC Power Supply" on page 363
●

Removing a Summit 450 W or 550 W AC Power Supply

Summit 450 W AC power supplies are used in Summit X480 series and X670 series switches. Summit
550 W AC power supplies are used only in Summit X670 series switches.
CAUTION
The power supply may be hot to the touch; wear thermal protective gloves when handling the power
supply during removal.
To remove a Summit 450 W or 550 W AC power supply:
1 Disconnect the AC power cord from the wall outlet and from the power input connector on the
power supply.
2 Push the latching tab to the right as you pull outward on the handle to disengage the power supply
internal connectors (see
Figure 301: Removing a 450 W or 550 W AC Power Supply
3 Carefully slide the power supply the rest of the way out of the switch.
362
Figure 301).
SH_139
Summit Family Switches Hardware Installation Guide