Installing A 300 W Ac Power Supply In A Summit X460 Series Switch - Extreme Networks Summit X150 Series Hardware Installation Manual

Chapter 6: Installing Summit Family Switches
the requirements listed under
.
page 464
Installing a 300 W AC Power Supply in a Summit X460 Series
Switch
WARNING!
To prevent an electrical hazard, make sure that the AC power cord is not connected to the power supply
before you install the power supply in the power supply bay.
CAUTION
Make sure that the AC power supply circuit is not overloaded. Use proper over-current protection, such as
a circuit-breaker, to prevent over-current conditions.
To install a 300 W AC power supply in a Summit X460 series switch:
1 If necessary, remove a blank panel from the back of the Summit X460 series switch
Figure 167: Removing a Blank Panel
2 Verify that the power supply is right side up (see
3 Carefully slide the power supply all the way into the power supply bay (see
power supply in until the latch snaps into place.
CAUTION
Do not slam the power supply into the switch.
224
"Power Cord Requirements for AC-Powered Switches and AC Power Supplies" on
Figure
SH_201
168).
Figure
Summit Family Switches Hardware Installation Guide
(Figure 167).
168). Push the