Front-Mounting A Switch In A Two-Post Rack - Extreme Networks Summit X150 Series Hardware Installation Manual

Chapter 6: Installing Summit Family Switches

Front-Mounting a Switch in a Two-Post Rack

To front-mount a Summit X670 series switch in a two-post rack:
1 Attach each mounting bracket as follows:
a Set the bracket against the switch housing, with the flange even with the front panel of the switch
(see Figure 220).
b Use six of the provided screws to secure the bracket to the switch housing.
c Repeat steps a and
Figure 220: Attaching a Rack-mounting Bracket
2 Slide the switch into the equipment rack
Figure 221: Installing the Summit X670 Series Switch
3 Secure the mounting bracket flanges to the rack, using screws that are appropriate for the rack.
(Rack-mounting screws are not provided.)
4 Ground the switch.
272
b to attach the other bracket to the other side of the switch.
(Figure 221).
Summit Family Switches Hardware Installation Guide