Vrrp Examples; Configuring The Simple Vrrp Network - Extreme Networks ExtremeWare XOS Guide Manual

Virtual Router Redundancy Protocol

VRRP Examples

This section provides the configuration syntax for the two VRRP networks discussed in this chapter.

Configuring the Simple VRRP Network

Figure 53 shows the simple VRRP network described in
Figure 53: Simple VRRP network
Switch A
Switch A = Master
VRID = 1
Virtual router IP address = 192.168.1.3
MAC address = 00-00-5E-00-01-01
Priority = 255
192.168.1.3
The following examples assume that you have already created the VLAN named vlan1 on the switch.
The configuration commands for switch A are as follows:
configure vlan vlan1 ipaddress 192.168.1.3/24
create vrrp vlan vlan1 vrid 1
configure vrrp vlan vlan1 vrid 1 prioirty 255
configure vrrp vlan vlan1 vrid 1 add 192.168.1.3
enable vrrp
The configuration commands for switch B are as follows:
configure vlan vlan1 ipaddress 192.168.1.5/24
create vrrp vlan vlan1 vrid 1
configure vrrp vlan vlan1 vrid 1 add 192.168.1.3
enable vrrp
ExtremeWare XOS 11.1 Concepts Guide
"Simple VRRP Network Configuration"
Switch B
Switch B = Backup
VRID = 1
Virtual router IP address = 192.168.1.3
MAC address = 00-00-5E-00-01-01
Priority = 100
192.168.1.5
Default Gateway = 192.168.1.3
section.
EX_068
362