Extreme Networks ExtremeWare XOS Guide Manual page 82

Configuring Slots and Ports on a Switch
To configure port speed and duplex setting, use the following command:
configure ports <port_list> auto off speed [10 | 100 | 1000 | 10000] duplex [half |
full]
To configure the system to autonegotiate, use the following command:
configure ports <port_list> auto on
Flow control on Gigabit Ethernet ports is enabled or disabled as part of autonegotiation. If
autonegotiation is set to Off on the ports, flow control is disabled. When autonegotiation is turned On,
flow control is enabled.
The 1 Gbps ports both advertise support and respond to pause frames, but they do not initiate pause
frames. The 10 Gbps ports always support flow control, and both types of ports initiate and respond to
pause frames. ExtremeWare XOS does not support turning off autonegotiation on the management port.
Beginning with ExtremeWare XOS 11.1, the 10 Gbps ports support the Link Fault Signal (LFS) function.
This function, which is always enabled, monitors the 10 Gbps ports and indicates either a remote fault
or a local fault. The system then stops transmitting or receiving traffic from that link. Once the fault is
alleviated, the system puts the link back up and the traffic automatically resumes.
The Extreme Networks implementation of LFS conforms to the IEEE standard 802.3ae-2002.
NOTE
On the BlackDiamond 10K switch, the 10 Gbps module must have the serial number 804405-00-09 or higher to
support LFS. To display the serial number of the module, issue the show slot <slot_number> command. (All
the modules on the Aspen 8810 switch support LFS.)
Although the physical link remains up, all Layer 2 and above traffic stops. The system sends LinkDown
and LinkUp traps when these events occur. Additionally, the system writes one or more information
messages to the syslog, as shown in the following example:
09/09/2004 14:59:08.03 <Info:vlan.dbg.info> MSM-A: Port 4:3 link up at
10 Gbps speed and full-duplex
09/09/2004 14:59:08.02 <Info:hal.sys.info> MSM-A: 4:3 - remote fault
recovered.
09/09/2004 14:59:05.56 <Info:vlan.dbg.info> MSM-A: Port 4:3 link down
due to remote fault
09/09/2004 14:59:05.56 <Info:hal.sys.info> MSM-A: 4:3 - remote fault.
09/09/2004 15:14:12.22 <Info:hal.sys.info> MSM-A: 4:3 - local fault
recovered.
09/09/2004 15:14:11.35 <Info:vlan.dbg.info> MSM-A: Port 4:3 link up at
10 Gbps speed and full-duplex
09/09/2004 15:13:33.56 <Info:vlan.dbg.info> MSM-A: Port 4:3 link down
due to local fault
09/09/2004 15:13:33.56 <Info:hal.sys.info> MSM-A: 4:3 - local fault.
09/09/2004 15:13:33.49 <Info:vlan.dbg.info> MSM-A: Port 4:3 link down
due to local fault
82
ExtremeWare XOS 11.1 Concepts Guide