Extreme Networks ExtremeWare XOS Guide Manual page 216

Quality of Service
NOTE
On the BlackDiamond 10K switch, this command applies only to untagged packets. On the Aspen 8810 switch, this
command applies to all packets.
Verifying Physical and Logical Groupings
You can display QoS settings on the ports or VLANs.
NOTE
On the BlackDiamond 10K switch, the screen displays both ingress and egress QoS settings. The 10Gbps ports have
8 ingress queues, and the 1 Gbps ports have 2 ingress queues.(Refer to
BlackDiamond 10K Switch Only" on page 221
shaping.)
To verify settings on ports or VLANs, use the following command:
show ports {<port_list>} information {detail}
Aspen 8810 switch display. You display which QoS profile, if any, is configured on the Aspen 8810
switch using the
show ports <port_list> information detail
output of this command for an Aspen 8810 switch:
Port: 8:1
Virtual-router: VR-Default
Type:
Random Early drop:
Admin state:
Link State:
Link Counter: Up
VLAN cfg:
Name: Default, Internal Tag = 1, MAC-limit = No-limit
STP cfg:
s0(disable), Tag=(none), Mode=802.1D, State=FORWARDING
Protocol:
Name: Default
Trunking:
EDP:
DLCS:
lbDetect:
Learning:
Flooding:
Jumbo:
BG QoS monitor: Unsupported
Egress Port Rate:
Broadcast Rate:
Multicast Rate:
Unknown Dest Mac Rate:
QoS Profile:
Ingress Rate Shaping :
ExtremeWare XOS 11.1 Concepts Guide
for more information on ingress queues, or bi-directional rate
EW
Disabled
Enabled with auto-speed sensing
Active
1 time(s)
Protocol: ANY
Load sharing is not enabled.
Enabled
Unsupported
Unsupported
Enabled
Enabled
Disabled
No-limit
No-limit
No-limit
No-limit
Qp3 Configured by user
Unsupported
"Bi-Directional Rate Shaping—
command. Following is a sample
auto-duplex
Match all protocols.
216