Configuring Telnet Access To The Switch - Extreme Networks ExtremeWare XOS Guide Manual

6 Configure the default route for the switch using the following command:
configure iproute add default <gateway> {vr <vrname>} {<metric>} {multicast-only |
unicast-only}
For example:
configure iproute add default 123.45.67.1
7 Save your configuration changes so that they will be in effect after the next switch reboot.
If you want to save your changes to the currently booted configuration, use the following
■
command:
save
ExtremeWare XOS allows you to select or create a configuration file name of your choice to save
■
the configuration to. If you want to save your changes to an existing or new configuration file,
use the following command:
save configuration [<existing-config> | <new-config>]
8 When you are finished using the facility, log out of the switch by typing:
or
logout quit

Configuring Telnet Access to the Switch

By default, Telnet services are enabled on the switch and all virtual routers listen for incoming Telnet
requests.
NOTE
The Aspen 8810 switch does not support user-created virtual routers.
To configure the virtual router from which you receive a Telnet request, use the following command:
configure telnet vr [all | default | <vr_name>]
To change the default TCP port number, use the following command:
configure telnet port [<portno> | default]
The range for the port number is 1 through 65535.
To display the status of Telnet, including the current TCP port, and the virtual router used to establish a
Telnet session, use the following command:
show management
You can choose to disable Telnet by using the following command:
disable telnet
To re-enable Telnet on the switch, use the following command:
enable telnet
You must be logged in as an administrator to configure the virtual router(s) used by Telnet and to
enable or disable Telnet.
ExtremeWare XOS 11.1 Concepts Guide
Using Telnet
49