Extreme Networks ExtremeWare XOS Guide Manual page 101

Aspen 8810 Switch Only. The following command displays more specific information for slot 3, port 1
on an Aspen 8810 switch:
show ports 3:1 information detail
Following is sample output from this command:
Port: 3:1
Virtual-router: VR-Default
Type:
Random Early drop:
Admin state:
Link State:
Link Counter: Up
VLAN cfg:
Name: Default, Internal Tag = 1, MAC-limit = No-limit
STP cfg:
s0(disable), Tag=(none), Mode=802.1D, State=FORWARDING
Protocol:
Name: Default
Trunking:
EDP:
DLCS:
lbDetect:
Learning:
Flooding:
Jumbo:
BG QoS monitor: Unsupported
Egress Port Rate:
Broadcast Rate:
Multicast Rate:
Unknown Dest Mac Rate:
QoS Profile:
Ingress Rate Shaping :
Ingress IPTOS Examination:
Egress IPTOS Replacement:
Egress 802.1p Replacement:
NetLogIn:
Smart redundancy:
Software redundant port:
BlackDiamond 10K Switch Only. The switch displays slightly different information for various ports,
depending on the speed and media.
The following command displays more specific information for a slot 1, port 1 on a BlackDiamond 10K
switch:
show ports 1:1 information detail
Following is sample output from this command:
Port: 1:1
Virtual-router: VR-Default
Type:
Random Early drop:
ExtremeWare XOS 11.1 Concepts Guide
UTP
Disabled
Enabled with auto-speed sensing
Active, 1 Gbps, full-duplex
1 time(s)
Protocol: ANY
Load sharing is not enabled.
Enabled
Unsupported
Unsupported
Enabled
Enabled
Disabled
128 Kbps, Max Burst Size: 200 Kb
No-limit
No-limit
No-limit
QP3 configured by user
Unsupported
Disabled
Disabled
Disabled
Disabled
Enabled
Disabled
UTP
Disabled
Displaying Port Configuration Information
auto-duplex
Match all protocols.
101