Displaying Counts Of Event Occurrences - Extreme Networks ExtremeWare XOS Guide Manual

Status Monitoring and Statistics
You must specify the TFTP host and the filename to use in uploading the log. There are many options
you can use to select the log entries of interest. You can select to upload only those messages that
conform to the specified:
Severity
●
Match expression
●
The uploaded messages can be formatted differently from the format configured for the targets, and you
can choose to upload the messages in order of newest to oldest or in chronological order (oldest to
newest).

Displaying Counts of Event Occurrences

EMS adds the ability to count the number of occurrences of events. Even when an event is filtered from
all log targets, the event is counted. To display the event counters, use the following command:
show log counters {<event condition> | [all | <event component>]} {include | notified
| occurred} {severity <severity> {only}}}
The system displays two counters. One counter displays the number of times an event has occurred,
and the other displays the number of times that notification for the event was made to the system for
further processing. Both counters reflect totals accumulated since reboot or since the counters were
cleared using the
clear log counters
The
show log counters
The included flag is set to Y(es) if one or more targets are receiving notifications of this event without
regard to matching parameters.
The keywords ,
include notified
the corresponding counter.
The output of the command:
show log counters stp.inbpdu severity debug-summary
is similar to the following:
Comp SubComp Condition
------- ----------- ----------------------- ------------- --------
STP InBPDU Drop
STP InBPDU Ign
STP InBPDU Mismatch
Occurred : # of times this event has occurred since last clear or reboot
Flags : (*) Not all applications responded in time with there count values
In(cluded): Set to Y(es) if one or more targets filter includes this event
Notified : # of times this event has occurred when 'Included' was Y(es)
The output of the command:
show log counters stp.inbpdu.drop
is similar to the following:
Comp SubComp Condition
------- ----------- ----------------------- ------------- --------
STP InBPDU Drop
ExtremeWare XOS 11.1 Concepts Guide
or
clear counters
command also displays an included flag (the column titled
, and display events only with non-zero counter values for
occurred
command.
Severity Occurred
Error
Debug-Summary
Warning
Severity Occurred
Error
in the output).
In
In Notified
-- --------
0 Y 0
0 N 0
0 Y 0
In Notified
-- --------
0 Y 0
142