Extreme Networks ExtremeWare XOS Guide Manual page 217

Ingress IPTOS Examination:
Egress IPTOS Replacement:
Egress 802.1p Replacement:
NetLogIn:
Smart redundancy:
Software redundant port:
NOTE
To ensure that you display the QoS information, you must use the detail variable.
BlackDiamond 10K switch display. You display information on the egress QoS profiles and the ingress
QoS profiles (shown as Ingress Rate Shaping), as well as the minimum and maximum available
bandwidth and priority on the BlackDiamond 10 K switch using the
command. The display is slightly different for a 1 Gbps port and for a 10 Gbps
information detail
port.
Following is sample output of this command for a BlackDiamond 10K switch 10 Gbps port:
Port: 8:1
Virtual-router: VR-Default
Type:
Random Early drop:
Admin state:
Link State:
Link Counter: Up
VLAN cfg:
STP cfg:
Protocol:
Trunking:
EDP:
DLCS:
lbDetect:
Learning:
Flooding:
Jumbo:
BG QoS monitor: Unsupported
QoS Profile:
Queue: Qp1
Qp2
Qp3
Qp4
Qp5
Qp6
Qp7
Qp8
Ingress Rate Shaping :
IQP1
IQP2
IQP3
IQP4
IQP5
IQP6
IQP7
ExtremeWare XOS 11.1 Concepts Guide
Disabled
Disabled
Disabled
Disabled
Enabled
Disabled
XENPAK
Disabled
Enabled with 10G full-duplex
Ready
0 time(s)
Load sharing is not enabled.
Enabled
Unsupported
Unsupported
Enabled
Enabled
Disabled
None configured
MinBw=0% MaxBw=100% Pri=1
MinBw=0% MaxBw=100% Pri=2
MinBw=0% MaxBw=100% Pri=3
MinBw=0% MaxBw=100% Pri=4
MinBw=0% MaxBw=100% Pri=5
MinBw=0% MaxBw=100% Pri=6
MinBw=0% MaxBw=100% Pri=7
MinBw=0% MaxBw=100% Pri=8
support IQP1-8
MinBw= 0% MaxBw=100% Pri=1
MinBw= 0% MaxBw=100% Pri=2
MinBw= 0% MaxBw=100% Pri=3
MinBw= 0% MaxBw=100% Pri=4
MinBw= 0% MaxBw=100% Pri=5
MinBw= 0% MaxBw=100% Pri=6
MinBw= 0% MaxBw=100% Pri=7
Traffic Groupings
show ports <port_list>
217