Configuring The Esrp Domain Id; Adding Vlans To An Esrp Domain - Extreme Networks ExtremeWare XOS Guide Manual

NOTE
If you use the same name across categories (for example, STPD and ESRP names) Extreme Networks recommends
that you specify the appropriate keyword as well as the actual name. If you do not specify the keyword, the switch
may display an error message.
The following example creates an ESRP domain named
create esrp esrp1
To delete an ESRP domain, use the following command:
delete esrp <esrpDomain>
The following example deletes the ESRP domain named esrp1:
delete esrp esrp1

Configuring the ESRP Domain ID

If you choose not use the 802.1Q tag (VLANid) of the master VLAN, or you have an untagged master
VLAN, you must create a domain ID before you can enable the ESRP domain. For more information
about ESRP domains and the ESRP domain ID, see
To configure an ESRP domain ID, use the following command:
configure esrp <esrpDomain> domain-id <number>
The parameter specifies the number of the domain ID. The user-configured ID range is 4096
number
through 65,535.
The following example creates a domain ID of 4097 for ESRP domain
configure esrp esrp1 domain-id 4097

Adding VLANs to an ESRP Domain

This section assumes that you have already created and configured the VLANs that you want to add to
the ESRP domain.
Adding and Deleting a Master VLAN
The master VLAN is the VLAN on the ESRP domain that exchanges ESRP PDUs and data between a
pair of ESRP-enabled devices. You must configure one master VLAN for each ESRP domain, and a
master VLAN can belong to only one ESRP domain.
To add a master VLAN to an ESRP domain, use the following command:
configure esrp <esrpDomain> add master <vlan_name>
The parameter specifies the name of the ESRP domain, and the
esrpDomain
specifies the name of the master VLAN.
ExtremeWare XOS 11.1 Concepts Guide
Configuring an ESRP Domain on a Switch
:
esrp1
"ESRP Domains" on page
:
esrp1
330.
parameter
vlan_name
337