Extreme Networks ExtremeWare XOS Guide Manual page 30

ExtremeWare XOS Overview
Table 3: ExtremeWare XOS version 11.1 global factory defaults (Continued)
Item
ESRP
QoS
QoS—802.1p replacement
QoS—DiffServ examination
Autonegotiation
802.3x flow control
Virtual LANs
802.1Q tagging
Spanning Tree Protocol
STPD port encapsulation mode
Forwarding database aging period
IP Routing
Smart Redundancy
System health check
RADIUS authentication port value
RADIUS accounting port value
OSPF link type
VRRP priority
IGMP
IGMP snooping
PoE power to port
PoE power per slot
PoE port priority
ELRP
Net Login
NOTE
For default settings of individual ExtremeWare XOS features, see individual chapters in this guide.
ExtremeWare XOS 11.1 Concepts Guide
Default Setting
Disabled
All traffic is part of the default queue (QP1).
Disabled
Disabled
• 10 G modules—autonegotiation OFF, speed 10000 Mbps, full-
duplex
• 1 G modules—autonegotiation ON
• 10 G modules—ON
• 1 G fiber and copper—ON
Two VLANs are predefined; the VLAN named default contains all
ports and belongs to the Spanning Tree Protocol Domain (STPD)
named s0. The VLAN mgmt exists only on switches that have an
Ethernet management port and contains only that port. The switch
uses the Ethernet management port for host operation only, not for
switching or routing.
All packets are untagged on the default VLAN (default).
Disabled for the switch; enabled for each port in the STPD.
• default STPD—802.1D mode
• user-created STPD—Extreme Multiple Instance Spanning Tree
Protocol (EMISTP)
300 seconds (5 minutes)
Disabled
Enabled
Enabled
1812
1813
Auto
100
Enabled
Enabled
Enabled
50 W
Low
Disabled
Disabled
30