Formatting Event Messages - Extreme Networks ExtremeWare XOS Guide Manual

Status Monitoring and Statistics
incidents, of severity and above, with a specific source MAC address, use the following
notice
command:
configure log filter myFilter add events aaa.radius.requestInit severity notice match
source mac-address 00:01:30:23:C1:00
The string type is used to match a specific string value of an event parameter, such as a user name. A
string can be specified as a simple regular expression.
Match Versus Strict-Match. The and keywords control the filter behavior for
match strict-match
those incidents with event definition that does not contain all the parameters specified in a
configure
command.
log filter events match
This is best explained with an example. Suppose an event in the XYZ component, named XYZ.event5,
contains a physical port number, a source MAC address, but no destination MAC address. If you
configure a filter to match a source MAC address and a destination MAC address, XYZ.event5 will
match the filter when the source MAC address matches regardless of the destination MAC address
because the event contains no destination MAC address. If you specify the keyword,
strict-match
then the filter will never match event XYZ.event5 because this event does not contain the destination
MAC address.
In other words, if the keyword is specified, an incident will pass a filter so long as all parameter
match
values in the incident match those in the match criteria, but all parameter types in the match criteria
need not be present in the event definition.

Formatting Event Messages

Event messages are made up of a number of items. The individual items can be formatted; however,
EMS does not allow you to vary the order of the items. To format the messages for a particular target,
use the following command:
configure log target [console | memory-buffer | nvram | session | syslog [all |
<ipaddress> | <ipPort>] {vr <vr_name>} {local0 ... local7}]] format [timestamp
[seconds | hundredths | none] | date [dd-mm-yyyy | dd-Mmm-yyyy | mm-dd-yyyy | Mmm-dd |
yyyy-mm-dd | none] | severity | event-name [component | condition | none |
subcomponent] | host-name | priority | process-name | process-slot | source-line
Using the default format for the session target, an example log message might appear as:
06/25/2004 22:49:10.63 <Info:dm.Info> MSM-A: PowerSupply:4 Powered On
If you set the current session format using the following command:
configure log target session format timestamp seconds date mm-dd-yyyy event-name
component
The same example would appear as:
06/25/2004 22:49:10 <dm> PowerSupply:4 Powered On
To provide some detailed information to technical support, set the current session format using the
following command:
configure log target session format timestamp hundredths date mmm-dd event-name
condition process-name source-line
140
ExtremeWare XOS 11.1 Concepts Guide