Extreme Networks ExtremeWare XOS Guide Manual page 341

ESRP Tracking Example
Figure 45 is an example of ESRP tracking.
Figure 45: ESRP tracking
Host 2:
200.1.1.14/24
Gateway:
200.1.1.1
Host 1:
200.1.1.13/24
Gateway:
200.1.1.1
To configure VLAN tracking, use the following command:
configure esrp esrp1 add track-vlan vlan1
Using the tracking mechanism, if VLAN1 fails, the ESRP master realizes that there is no path to the
upstream router via the master switch and implements an ESRP failover to the slave switch.
To configure route table tracking, use the following command:
configure esrp esrp1 add track-iproute 10.10.10.0/24
The route specified in this command must exist in the IP routing table. When the route is no longer
available, the switch implements an ESRP failover to the slave switch.
To configure ping tracking, use the following command:
configure esrp esrp1 add track-ping 10.10.10.121 frequency 2 miss 2
The specified IP address is tracked. If the fail rate is exceeded, the switch implements an ESRP failover
to the slave switch.
ExtremeWare XOS 11.1 Concepts Guide
ESRP master
200.1.1.1/24
vlan esrp1
L2 switch
ESRP slave
200.1.1.2/24
Advanced ESRP Features
(track-vlan)
vlan vlan1
Router
10.10.10.121
EX_094
341