Extreme Networks ExtremeWare XOS Guide Manual page 68

Managing the Switch
Table 10: Time zone configuration command options (Continued)
floating_day Specifies the day, week, and month of the year to begin or end Daylight Savings Time
each year. Format is:
<week> <day> <month> where:
• <week> is specified as [first | second | third | fourth | last]
• <day> is specified as [sunday | monday | tuesday | wednesday | thursday | friday |
• <month> is specified as [january | february | march | april | may | june | july | august |
Default for beginning is first sunday april; default for ending is last sunday october.
absolute_day Specifies a specific day of a specific year on which to begin or end DST. Format is:
<month> <day> <year> where:
• <month> is specified as 1-12
• <day> is specified as 1-31
• <year> is specified as 1970 - 2035
The year must be the same for the begin and end dates.
time_of_day_hour Specifies the time of day to begin or end Daylight Savings Time. May be specified as an
hour (0-23). Default is 2.
time_of_day_minut Specify the minute to begin or end Daylight Savings Time. May be specified as a minute
es (0-59).
noautodst Disables automatic Daylight Savings Time.
Automatic Daylight Savings Time changes can be enabled or disabled. The default setting is enabled.
To disable automatic Daylight Savings Time, use the command:
configure timezone {name <std_timezone_ID>} <GMT_offset> noautodst
3 Enable the SNTP client using the following command:
enable sntp-client
After SNTP has been enabled, the switch sends out a periodic query to the NTP servers defined in
step 4 (if configured) or listens to broadcast NTP updates from the network. The network time
information is automatically saved into the onboard real-time clock.
4 If you would like this switch to use a directed query to the NTP server, configure the switch to use
the NTP server(s). If the switch listens to NTP broadcasts, skip this step. To configure the switch to
use a directed query, use the following command:
configure sntp-client [primary | secondary] <host-name-or-ip> {vr <vr_name>}
NTP queries are first sent to the primary server. If the primary server does not respond within 1
second, or if it is not synchronized, the switch queries the secondary server (if one is configured). If
the switch cannot obtain the time, it restarts the query process. Otherwise, the switch waits for the
sntp-client update interval
5 Optionally, the interval for which the SNTP client updates the real-time clock of the switch can be
changed using the following command:
configure sntp-client update-interval <update-interval>
The default
sntp-client update-interval
ExtremeWare XOS 11.1 Concepts Guide
saturday]
september | october | november | december]
before querying again.
value is 64 seconds.
68