JVC GR-DVM75 Instructions Manual page 81

23. Even when Slow Shutter is 23. • When shoothlg in the dark, 23. • If you want the lighthlg to
not selected, the image _ooks the unit becomes highly look more natural, set "GAIN
like it is activated, sensitive to light and the UP" to "AGC" or "OFF' in the
image takes on an effect Menu Screen ( "pg. 39).
similar to Slow Shutter.
24. Thereis no strobe when the 24. *The Picture Wipeor Dissolve 24. * Do not tryto usetheClassic
Classic Film or Strobe mode function is in use. Film or Strobe mode during a
is activated, scene transition / ' pg. 46,
48).
25:. White Balance cannot be 25:. *The Sepia or Monotone mode 25:. *Turn offSepia or Monotone
activated, is activated, betore setting White Balance
(. " pg. 47, 53h
26. • This is a lesuIt of exceedingly 26.
high contrast, and is not a
malfunction.
26. When shooting a sub ect
illuminated by bright light,
vertical lines appear;
27. When the screen is under
direct sunlight durin
shooting, the screen_ecomes
red or black for an instant.
27. • This is not a maltunction. 2Z
28. During recording, the date/ 28. • "DATE/TIME" is set to "OFF" 28. • Set "DATE/TIME" to "ON" in
time does not appea_: in the Menu Screen. the Menu Screen ( "pg. 41 h
29. Files stored in the memory 29. • Files stored in the memory 29. • Remove protection from the
card cannot be deleted, card are protected, files stored in the memory
card and delete them
(. "pg. 31 33).
30. The indicator s and messages 30. • "TIME CODE" is set to "E)FF" 30. * Set "TIME CODE" to "ON" in the
do not appear, in the Menu Scleen. Menu Semen _- pg. 4L 42).
31. • I11places subject to low
temperature, images become
dark due to the characteristics
of the LCD monitor. When
this happens, the displayed
colours differ from those that
are actually recorded. This is
not a defect of the camcorder.
• When the LCD monitoPs
fluorescent light reaches the
end of its service life, images
on the LCD monitor become
dark. Consult your nearest
/VC dealel.
31. Images on the LCD monitor
appear dark or whitish.
33. • This may occur when the
surface or the edge of the LED
monitor is pressed.
31. * Adjust the brighmess and
angIe of the LCD monitor
(." pg. 18, 19k
32. The rear ofthe LCD monitor 32. *The light used to illuminate 32. * Close the LCD monitor toturn
is hot. the LCD monitor causes it to it off or set the Power Switch
become hot. to "OFF", and let the unit cool
down.
33. The indicators and the image 33.
color on the LCD monitor
are not dea_
CONTINUED ON N[XT PAGE