JVC GR-DVM75 Instructions Manual page 78

If, after
loilowing
the steps in tile chart below, the problem still exists, please consult your nearest JVC
dealer.
The camcorder is a miclocomputer-controlled device. External noise and interference (flom a TV, a ladio,
etc.) might plevent it from functioning properly. In such cases, filst disconnect its power supply unit (battery
pack, A( Adapter, etc.) and wait a few minutes; and then re-connect it and proceed as usual from the
beginning.
1. No power is supplied. 1. • The power is not connected 1. • Connect tile AC Adapter
securely pg. 9).
• Replace tile dead bar, ely with a
fully charged one ( "pg. 8, 9).
• Open the LCD monitor futly
or pull out tile viewfindel.
2. "SET DATE/TIME!" appears. 2. • Set the date/time ( ' pg.l l).
• Consult your nearest JVC
dealer fur replacement.
3. Recording cannot be 3.
peffurmed.
• Set the tape's erase protection
tab to "REC" pg. 12).
• Set the Power Switch to
"n'or"[_'( _ pg. 16).
• The VIDEO/DgC Switch is set
to "VIDE()".
• Replace with new cassette
( pg. 12).
• Close the cassette holder
covel.
• The VIDEO/DSC Switch is set
properly.
• The bakery is dead.
• The LCD monitor is not open
futly or the viewfinder is not
pulled out when recording.
• Tile date/time is not set. 2.
• The built in clock battery has
run out and the previously set
date/time has been erased.
For Video Recordhlg 3.
• The tape's erase plotection tab
is set to "SAVE".
• The Power Switch is set to
"_" or "OFF".
• The VIDEO/DSC Switch is set
• "TAPE END" appears.
• The cassette homer cover is
open.
For D.S.C. Recording
• The VIDEO/DSC Switch is set
to "VIDEO".
• The camcorder is not getting 4.
F_-_wel;or some othe_
malfunction exists.
• The Power Switch is set to _'.
• Focus is set to the Manual 6.
mode.
• The recording was clone in a
dark place, or the contrast
was
lOW.
• The lens is dirty or covered
with condensation.
• The cassette is in the wrong 2'.
position.
• The batlery's charge is low.
• The memory card is in the &
wrong position.
• The Squeeze mode is 9.
selected.
4. There is no picture. 4. • Turn tile camcorder's power
off and on again( "pg. 16h
_'. Some functions are not 5. • Set the Power Switch to "[M"
available using the MENU pg. 1 _'_).
Wheek
6. Tile focus does not adjust 6. • Set Focus to the Auto mode
automatically, pg. 51h
• Clean the lens and check the
fucus again ( pg. 84).
2'. Tile cassette will not load 7. • Set it in tile right position
properly. (" pg. 12).
• Install a fully charged battery
( 'pg. 8,9).
Tile memo card will not 8. • Set it in tile right position
& load propetl_y. ( " pg. 14).
9. Snapshot mode cannot be 9. • Disengage the Squeeze mode
used. (' pg. 40).