JVC GR-DVM75 Instructions Manual page 58

58E"
Dubbing ToOrFrom A VideoUnitEquipped
WithA DV Connector (Digital D ubbing)
It is also possible to copy recorded scenes flora the
camcorder onto anothel video unit equipped with a DV
connector. Since a digital signa{ is sent, there is litde if
any image or sound deterioration.
[To use this camcorder as a player]
To DV IN/OUT
Core filter DV cable
(optional)
To DV IN/OUT
Video unit
equipped with DV
€onnector
Make sule all units are turned off, Connect the
camcoldel to a video unit equipped with a DV input
connector using a DV cable as shown in the
illustration,
Set tile VIDEO/DSC Switcln to "VIDE()" (GR-
DVM75 only), set tile camcordeVs Powel Switch to
"[_" while pressing down tile Lock Button
located on tile switch, turn on the video unit's
powe,, and insert timeappropriate cassettes in the
camcoldel and the video unit.
Press I_/11 to play back the source tape.
Wlnile watching the playback on tile monitol,
engage the DV connectol-equipped video unit's
record mode from the spot on the source tape you
want to begin lecolding.
NOTES:
• It is recommended to use the AC Adapter as the power supply instead of the battery pack (_ pg. 8).
• If the renlol_ control is used when both the player and recorder are/VC video units, both unils wilt
perform lhe same operation. To prevent this from happening; press the buttons on both units.
• If a blink portion or disturbed image is pklyed back on the play#i during dubbing, the dubbing may stop
so that an unusual image is not dubbed.
• Even though the DV cable is connected correctly, sometimes the image may not appear in stpp 4. If this
occurs, turn off the power and make conneclions again.
• If "Playback Zoom" (:: pg, 64), "Playback Special Effects" (:: pg, 65) or "Snapshot" is attempted during
ptayback_ only the original pklyback image recorded on the lape is output from the DV IN/OUT
connectol_
• When using a DV cable, be sure to use the optional JVC VC-VDV204U DV cable.
To Use This Camcorder As A Recorder...
1. Set the VIDEO/DSC Switch to "VIDE()" (GR-DVM75 only), then set the Powel Switch to "1_"
while pressing down the Lock Button located on the switch.
2. Set "REC MODE" to "SP" or "LP" in the Menu Screen (," pg, 42).
3. Connect the DV cable as shown in tile illustration and load a cassette to lecoId on,
4. Press the Recording Start/Stop button to engage the Record-Pause mode. "O_IN" appears on tile
screen.
5. Press the Recording Stad/Stop button to start recording, _ rotates.
6. Press the Recording Stair/Stop button again to engage timeRecord-Pause mode. _ stops rotating.
NOTES:
• Digital Dubbing is performed in the sound n!od_ recorded on tile orig_nat Iap_, regardless oflhe
current "SOUND MODE" setting (: pg, 39).
• During Digital Dubbing, no signals are output tkonl the AV output connector.