JVC GR-DVM75 Instructions Manual page 20

20EN
Time Code
During recording, a time code is lecolded on the tape. This code is to confiml the location of the recorded
scene on tile tape during ptayba(k.
If lecording starts fiom a blank portion, the time code begins counting lrom "00:00:00"
(minute:second:franle). If lecolding starts from the end of a previously lecolded scene, the time code
continues from the last time code numbeL
To perform Random AssemNe Editing (: pg. 69 73), time code is necessary, If duling lecolding a blank
portion is left partway through the tape, the time code is interrupted, When recolding is resunled, the time
code starts counting up again flora "00:00:00'% This means the camcordel nlay lecord the same time
codes as those existing in a previously recolded scene, To plevent this, periorm "Recolding Fiom The
Middle of A Tape" be[ow in the following cases;
• When shooting again after playing back a Display
recolded tape, Frames are not displayed
• When power shuts off during shooting, during recording.
• When a tape is lenloved and re-inselted during Minutes
shooting,
• When shooting using a paltiaHy recorded tape, Seconds
• When shooting on a b[ank poltion located
partway though the tape.
Frames
• When shooting again aftel shooting a scene (30 frames = 1 second)
then opening/closing the cassette holdel cover,
Recording From TheMiddle Of ATape
1. Play back a tape or use BJank Search pg. 24) to find the spot at which you want to start recording,
then engage the Still Playback mode (:" pg. 21).
2. Setthe Power Switch to "D " or "[M" while pressing down the Lock Button located on the switch, then
staff recording,
NOTES:
• Tile time _od_ rannot be reset.
• During t'ast#brwarding and rewinding, the time code indication (foes not move smoothl F
• Tile time _od_ is displayed only when "TIME CODE" is sel lo "ON" (: pg. 4 t, 42L
When a blank portion is recorded on a tape
Timecode Timecode Timecode
00:00:00 05:43:2t 00:00:00
Shooting startpoint Shootings_op point Shootings_arl F aint
Proper recording
Time code Time code Time code
00:00:00 05:43:2t 05:44:00
Shooting start point Shooting s_arl point Shooting s_arl point