JVC GR-DVM75 Instructions Manual page 73

GR-DVM75 only
Random Assemble
Editing Menu
VIDEO Menu
ForMoreAccurate Editing
Some VCRs make the transition from Record-Pause to
Record mode faster than othels. Even if you begin editing
lol g/e camcorder and the VCR at exactly the same time,
you may lose scenes you wanted, ol find that you have
recorded scenes you did not want. Fol a cfean]y edited
tape, confirm and adjust the timing of the camcoldel
against your VCR.
DIAGNOSING VCR/CAMCORDER TIMING
Play back the tape in the camcoldeb then point the
remote control at the canlcordel _s le{Tlote sensor
and press R.A.EDIT ON/OFF,
Random Assemble Editing Menu appears,
Perform Random Assemble Editing on Program 1
only. hi order to check VCR and camcordel timing,
select the beginning of a scene tlansition as your
Edit-in poinL
Play back the dubbed scene.
• If any images flora the scene priol to the
transition you chose for your Edit-In point were
recorded, that means your VCR moves too quickly
irom Record-Pause to Recold mode.
• If the scene you tried to dub stalts ill progress, the
VCR is slow to stalt recording.
Remote sensor
ADJUSTMENT OF VCR/CAMCORDER
TIMING
--R.A.EDIT
ON/OFF
NOTES:
• Before performing actual Random Assemble
Editing, do a few Random A_embfe Editfng
trial runs to dteck whether lhe value you
have input is appropriate or not, and make
adjuslmenls accordingly.
• Depending on the recorder, lbere nlay be
situations where lhe timing difference
cannot be fully correcled.
Point the remote contlol at the camcorder's remote
sensor and press R.A.EDIT ON/OFF to make the
Random Assembfe Editing nlenu disappear, then
pless the MENU Wheel in. The Menu Screen
appears.
Rotate the MENU Wheel to select .1_ VIDEO" and
pless it, The VIDEO Menu appears, Then, rotate it to
"SYNCHRO" and press it, The value for
"SYNCHRO" is highlighted.
Based on the diagnostics performed, you can now
advance the VCR's record timing by rotating the
MENU Wheel towards "+". You can also delay the
VCR's lecold timing by rotating the MENU Wheel
towards "-'% The adjustment range is from 1.3 to
+1,3 seconds, in 0.1 -second increments.
hess the MENU Wheel to finish the setting.
Rotate the MENU Wheel to select "TJRETURN" and
p_essit twice,
Now perform Random Assemble Editing beginning
with step 4 on page 71,