Table of Contents
Advertisement
TIMER RECORDING ON HDD/DVD DECK
46
EN
Manual Timer Programming
You can programme this unit to timer record as many as 16
programmes.
If you do not know the S
HOW
wish to record, use the following procedure to set your unit to timer
record the programme.
●
Make sure that the unit's built-in clock is set properly.
●
Turn on the unit.
●
Turn on the TV and select the AV mode.
●
Slide the TV/CABLE/SAT/DVD switch to DVD.
ENTER
1
Load a recordable disc if recording to DVD.
2
Press PROGRAMME to access the programme top screen.
3
Press selection keys to select ACALENDAR PR.B, then press
ENTER.
●
When APROGRAMME FULL DELETE UNWANTED TIMER
PROGRAMMESB appears on the TV screen, you need to
cancel some of the reserved programmes. (A pg. 47)
4
Press selection keys to select the desired date, then press
ENTER.
5
Press selection keys to select
ARECORD TOB, then press
ENTER. Press selection keys
to select the desired recording
deck, then press ENTER.
6
Press selection keys to select
ASTARTB, then press ENTER.
Press selection keys to set
the desired start time, then
press ENTER.
Each press of F G increases/decreases the start time in 1-
●
minute intervals.
●
To increase/decrease the start time in 30-minute intervals,
press and hold F G.
7
Press selection keys to select ASTOPB, then press ENTER.
Press selection keys to set the desired stop time, then press
ENTER.
Each press of F G increases/decreases the stop time in 1-
●
minute intervals.
●
To increase/decrease the stop time in 30-minute intervals,
press and hold F G.
V
number for the programme you
IEW
CABLE/SAT
TV
DVD
PROGRAMME
Selection Keys
FGDE
2
PROGRAMME > CALENDAR PR. (2/3)
14/01/04 WED 22:30 - 23:00
SELECT WITH @
RECORD TO
THEN PRESS [ENTER]
START
PRESS [PROGRAMME]
STOP
TO EXIT
TV PROG
PROGRAMME
ENTER
CONFIRM
EXIT
SELECT
8
Press selection keys to select ATV PROGB, then press ENTER.
Press selection keys to select the desired channel.
9
Press selection keys to select ACONFIRMB, then press
ENTER.
10
Set the other recording options as required.
●
Refer to step 8 in AS
(A pg. 44).
11
Press selection keys to
select AOKB, then press
ENTER to access the
Programme Confirmation
screen.
12
Press selection keys to
select AEXITB, then press
ENTER to complete timer
programming.
●
To programme another timer, press selection keys to select
ACONTINUEB, then press ENTER.
●
If APROGRAMME OVERLAPPEDB appears on the TV
screen, delete or modify the programmes.
NOTES:
●
When two successive programmes are recorded on a DVD-RW
disc with Manual Timer Programming function, the beginning of
the second one may be left off the recording.
●
If the copy limited programme is received during timer recording,
the unit enters Record Pause mode. Recording starts again if it is
switched to a recordable broadcast during the time you
programmed.
Satellite Receiver Users
To timer record a satellite broadcast using Manual Timer
Programming:
A Perform AManual Timer ProgrammingB on this page.
In step 8, set ATV PROGB to AL-2B.
B Set the satellite receiver to the appropriate channel before
the selected programme begins.
C Leave the satellite receiver's power on.
Relief Recording
When a programme that is set for the DVD deck cannot be
recorded properly, the programme is recorded to the HDD deck
instead in the recording mode as set.
●
If the remaining capacity of the hard disk is not sufficient, the
programme is recorded to the DVD deck until the remaining
capacity of the DVD disc lasts.
●
If AJUSTB is selected for the recording mode, the current
recording mode for the DVD deck is applied.
BBC1
[MISC. ] XP
HDD
22:30
23:00
BBC1
V
Timer ProgrammingB
HOW
IEW
2
PROGRAMME > CALENDAR PR. (3/3)
14/01/04 WED 22:30 - 23:00
GARDENING
SELECT WITH @
INPUT TITLE
THEN PRESS [ENTER]
CATEGORY
PRESS [PROGRAMME]
VPS/PDC
TO EXIT
WEEKLY/DAILY
REC MODE
PROGRAMME
ENTER
EXIT
SELECT
BBC1
[EDUCATION] FR360
1:00
28:00
GARDENING
EDUCATION
OFF
MON-FRI (FOR A WEEK)
FR360
OK
Advertisement
Table of Contents
