Table of Contents
Advertisement
Important Safety information
WARNING:
To reduce the risk of personal injury or damage to the equipment, ensure that only one hard drive
drawer is extended at a time.
Replacing a hard drive within the enclosure is an online activity, providing the following general guidelines
are observed:
•
When the drawer is opened, the cooling fans in the enclosure will run at full-speed. This is normal.
•
Hard drives are sensitive to excessive vibration. Use care when opening and closing the drawer.
•
Never leave the drawer open for any length of time. It should be opened only for maintenance and
storage expansion.
•
Verify that the drives are fully seated before closing the drawer.
•
The drawer is fully closed when the fans slow down to their normal speed.
•
The drawer should be closed with the handle in the released position.
NOTE:
Remember to close the handle after closing the drawer
Installing the drives in a StoreOnce disk enclosure
Procedure
1. If you are using HPE StoreOnce Remote Support on your system, run the following StoreOnce CLI
command to suppress remote event reporting:
system enable remoteeventsuppression "Disk Maintenance"
2. Identify which drive needs replacing and its drawer and bay location. This information may be provided
from SNMP alerts or from the StoreOnce GUI on the Events or Hardware pages. For example,
expand the Hardware tree until you locate the item that has failed.
54
Important Safety information
Advertisement
Table of Contents
