Help - GE MultiLink ML1200 Instruction Manual

CHAPTER 1: INTRODUCTION
1.4.9

Help

MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL
Typing the command lists the commands you can execute at the current privilege
help
level. For example, typing
help
ML1200
help
>
logout ping
terminal telnet
Contextless Commands:
! ?
enable exit
show whoami
alarm
ML1200
>
Help for any command that is available at the current context level can be viewed by
typing help followed by enough of the command string to identify the command. The
following syntax applies:
help <command string>
For example, to list the help for the
ML1200#
help set time
set time : Sets the device Time
Usage
set time hour=<0-23> min=<0-59> sec=<0-59> [zone=GMT[+/-]hh:mm]
ML1200#
The options for a specific command can be displayed by typing the command and
pressing enter. The following syntax applies:
command <Enter>
For example, the options for the
ML1200#
show <Enter>
Usage
show active-stp
show active-snmp
show active-vlan
show address-table
show age
show alarm
show arp
show auth <config|ports>
show backpressure
show bootmode
--more--
Other ways to display help, specifically, with reference to a command or a set of
commands, use the TAB key. The following syntax applies:
<TAB>
<Command string> <TAB>
<First character of the command> <TAB>
For example, following the syntax listed above, the <TAB> key will list the available
commands in the particular privilege level:
ML1200>
<TAB>
at the Operator level shows the following:
set
walkmib
clear
help
command
set time
command are:
show
INTRODUCTION
1–13