Saving Configuration - GE MultiLink ML1200 Instruction Manual

IP ADDRESSING
ML1200#
[HARDWARE]
type= ML1200
slotB=8 Port TP Module
##########################################################
# System Manager - This area configures System related
#
##########################################################
[SYSTEM]
***Edit below this line only****
system_name=Main
system_contact=someone@joe.com
system_location= Markham, Ontario
boot_mode=manual
system_ip=192.168.1.15
system_subnet=0.0.0.0
system_gateway=192.168.1.11
idle_timeout=10
telnet_access=enable
snmp_access=enable
web_access=enable
--more—
...
5.4.4

Saving Configuration

5–20
show config module=snmp,system
information.
FIGURE 5–4: Displaying configuration for different modules.
Note – multiple modules can be specified on the command line
It is advisable to save the configuration before updating the software, as it may be
necessary in certain situations. The
new configuration. Without a reboot, the ML1200 used the previous configuration. When
reboot is selected, the user is prompted as follows:
Reboot? ['Y' or 'N']
Select "Y". The ML1200 will prompt:
Save Current Configuration?
Select "N".
command requires a reboot to activate the
loadconf
MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL
CHAPTER 5: IP ADDRESSING
#
#