Configuring Port Security Through The Command Line Interface; Commands - GE MultiLink ML1200 Instruction Manual

CHAPTER 6: ACCESS CONSIDERATIONS
6.2

Configuring Port Security through the Command Line Interface

6.2.1

Commands

MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL
To configure port security, login as a level 2 user or as a manager. Once logged in, get to
the port-security configuration level to setup and configure port security with the following
command syntax:
configure port-security
port-security
For example, using the
configure port-security
ML1200#
configure port-security
ML1200(port-security)##
Alternately, the
port-security
configuration mode:
ML1200#
port-security
ML1200#(port-security)##
From the port security configuration mode, the switch can be configured to:
1. Auto-learn the MAC addresses.
2. Specify individual MAC addresses to allow access to the network.
3. Validate or change the settings.
The command syntax for the above actions are:
allow mac=<address|list|range>
port=<num|list|range>
learn port=<number-list> <enable|disable>
show port-security
action port=<num|list|range>
<none|disable|drop>
signal port=<num|list|range>
<none|log|trap|logandtrap>
ps <enable|disable>
remove mac=<all|address|list|range>
port=<num|list|range>
signal port=<num|list|range>
<none|log|trap|logandtrap>
Where the following hold:
• - configures the switch to setup allowed MAC addresses on specific
allow mac
ports
• - configures the switch to learn the MAC addresses associated with
learn port
specific port or a group of ports
•
show port-security
learnt
• - specifies the designated action to take in case of a non
action port
authorized access
• - port security - allows port security to be enable or disabled
ps
command:
command can also be used to enter the port-security
- shows the information on port security programmed or
ACCESS CONSIDERATIONS
6–3