Help - GE MULTILINK ML2400 Instruction Manual

CHAPTER 1: INTRODUCTION
1.5.9

Help

MULTILINK ML2400 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
To add a user, use the
add
name. The password is recommended to be at least 8 characters long with a mix of upper
case, lower case, numbers and special characters.
add user=<name> level=<number>
The following example adds a user "peter" with manager-level privilege:
ML2400#
user
ML2400(user)##
add user=peter level=2
Enter User Password:******
Confirm New Password:******
ML2400(user)##
To delete a user, use the
delete
delete user=<name>
The following example deletes the user "peter":
ML2400(user)##
delete user=peter
Confirm User Deletion(Y/N):
User successfully deleted
ML2400(user)##
The syntax to modify a password is shown below:
passwd user=<name>
The following example changes the password for user "peter".
ML2400(user)##
passwd user=peter
Enter New Password:******
Confirm New Password :******
Password has been modified successfully
ML2400(user)##
The syntax to modify the privilege level for a specific user is shown below:
chlevel user=<name> level=<number>
The following example modifies the privilege level of user "peter" to Operator privileges.
ML2400(user)##
chlevel user=peter level=1
Access Permission Modified
ML2400(user)##
The syntax to set the access privileges for telnet and Web services is shown below:
useraccess user=<name> service=<telnet|web> <enable|disable>
The following example sets the access privileges for telnet and Web services.
useraccess user=peter service=telnet disable
ML2400(user)##
Telnet Access Disabled.
Typing the command lists the commands you can execute at the current privilege
help
level. For example, typing
help
ML2400
help
>
command as shown below. The user name has to be a unique
command as shown below.
Y
at the Operator level shows the following:
INTRODUCTION
1–15