Appendix A. Command Language Interface (CLI)
Execution Modes
The CLI contains several execution modes. Users will see different set of commands under different execution
modes. The following table lists all the execution modes and their purposes. When users enter a certain
execution mode, the corresponding mode prompt will be displayed automatically on the screen. The mode
prompts of all the execution modes are also listed below.
Mode
Init Mode
Enable Mode
Config Mode
Alarm Profile Config Mode
Gigabit Interface Config Mode
ACL Profile Config Mode
scheduler Profile Config Mode
Vlan Interface Config Mode
IGMP MVR Profile Config Mode
IGMP ACL Profile Config Mode
RingV2 Group Config Mode
Trunk Group Config Mode
Getting help
The user can get help by entering a question mark '?' at each position in the command. The displayed result
depends on the execution mode and previous input.
46
PACSystems PROFINET Managed Industrial Ethernet Switches User Manual
Figure 40: Telnet Login Screen
Access Level
Guest
Guest
Guest
Engineer
Engineer
Engineer
Engineer
Engineer
Engineer
Engineer
Engineer
Engineer
Prompt
>
#
(conf)#
(alarm-profile-conf)#
(gigabit-intf-conf)#
(acl-profile-conf)#
(sch-profile-conf)#
(vlan-intf-conf)#
(igmp-mvr-profile-conf)#
(igmp-acl-profile-conf)#
(ring)#
(trunk-group-conf)#
GFK-3030