GE MultiLink ML1200 Instruction Manual page 218

RAPID SPANNING TREE PROTOCOL
Configuring RSTP (continued)
RSTP Port Configuration
-------------------------------------------------------------------------------
Port# Type Priority
-------------------------------------------------------------------------------
01 TP(10/100)
02 TP(10/100)
03 100MB Fiber
04 100MB Fiber
05 100MB Fiber
06 100MB Fiber
07 TP(10/100)
forceversion rstp
ML1200(rstp)##
Error: Force Version already set to Normal RSTP
forceversion stp
ML1200(rstp)##
show-forceversion
ML1200(rstp)##
Force Version : Force to STP only
show stp config
ML1200(rstp)##
RSTP CONFIGURATION
-----------------
Rapid STP/STP Enabled(Global) : YES
RSTP/STP Enabled Ports
Protocol
Bridge ID
Bridge Priority
Bridge Forward Delay
Bridge Hello Time
Bridge Max Age
Root Port
Root Path Cost
Designated Root
Designated Root Priority
Root Bridge Forward Delay
13–10
Path Cost State
128 2000000 Forwarding
128 200000 Forwarding
128 200000 Disabled
128 200000 Disabled
128 200000 Disabled
128 200000 Disabled
128 2000000 Disabled
: 1,2,3,4,5,6,7
: Force to STP only
: 80:00:00:20:06:2b:e1:55
: 32768
: 15
: 02
: 20
: 0
: 0
: 80:00:00:20:06:2b:e1:55
: 32768
: 15
CHAPTER 13: RAPID SPANNING TREE PROTOCOL
Des. Bridge
80:00:00:20:06:2b:e1:55
80:00:00:20:06:2b:e1:55
The
forceversion
used for compatibility with STP
devices. In this example, the switch is
forced to STP mode.
Using
operating using RSTP. Note the
stp config
the switch protocol is RSTP.
MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL
Des. Port
00:01
00:02
00:03
00:04
00:05
capability can be
00:06
00:07
, the switch is now
forceversion
show
command also indicates