GE MultiLink ML1200 Instruction Manual page 217

CHAPTER 13: RAPID SPANNING TREE PROTOCOL
Example 13-4: Configuring RSTP
rstp
ML1200#
show stp config
ML1200(rstp)##
RSTP CONFIGURATION
-----------------
Rapid STP/STP Enabled(Global) : NO
RSTP/STP Enabled Ports
Protocol
Bridge ID
Bridge Priority
Bridge Forward Delay
Bridge Hello Time
Bridge Max Age
Root Port
Root Path Cost
Designated Root
Designated Root Priority
Root Bridge Forward Delay
Root Bridge Hello Time
Root Bridge Max Age
Topology Change count
Time Since topology Chg
show active-stp
ML1200(rstp)##
Current Active Mode: RSTP.
RSTP is Disabled.
rstp enable
ML1200(rstp)##
Successfully set the RSTP status
show active-stp
ML1200(rstp)##
Current Active Mode: RSTP.
RSTP is Enabled.
show stp config
ML1200(rstp)##
RSTP CONFIGURATION
-----------------
MULTILINK ML1200 MANAGED FIELD SWITCH – INSTRUCTION MANUAL
: 1,2,3,4,5,6,7
: Normal RSTP
: 80:00:00:20:06:2b:e1:55
: 32768
: 15
: 02
: 20
: 0
: 0
: 80:00:00:20:06:2b:e1:55
: 32768
: 15
: 02
: 20
: 0
: 935
RAPID SPANNING TREE PROTOCOL
Check the status of STP or RSTP. These
commands show if STP or RSTP is
enabled.
13–9